Dented garage door panels in Bonita Springs: repaired, or replaced one section at a time
A single damaged section rarely means the whole door has to go. If everything else is solid, that one section can usually be swapped, matched to the model. Ordering it takes the brand and model from the door's label, so photographing that sticker saves a trip.
- Time at your house: One to two hours after the replacement section is delivered
- Licensed in Florida: CGC15***47
Damage we see on panels
- A dent from a car bumper, a basketball or a branch in a storm.
- A crack along a section joint, or a split near the hinges.
- Rust coming through on the bottom section, where water and salt sit longest.
- A section pushed in by strong wind, so the door binds or won't seal; read about impact doors if that's how it happened.
- A section buckled and the door came off track; see off-track doors.
Fix it, replace one section, or replace the door
A shallow dent that stays clear of the joints can be left alone. A cracked or bent section should be replaced, because it weakens the door in wind. Matching depends on the maker and the model, and the label, usually on the inside near a top corner or on an end stile, gives us both. If the model is no longer made, or three or more sections are damaged, we'll price a new door next to the section repair so you can compare.
Wind-rated doors need matching parts
A door that carries a state product approval was tested as one assembly: sections, struts and hardware together. Swapping in a section made for another model can put the door outside that approval. We read the label first and order parts that keep the rating intact.
Ordering the section
Sections come from the maker. You get the factory's delivery date by text on the day they confirm it, and the install date as soon as the section is in our hands. Suspect more than a panel? Our troubleshooting guide helps sort it out, and a door stuck open tonight is an emergency call.
Permit
Swapping a section for its exact match is a repair, while replacing the whole door always takes a City of Bonita Springs permit (its building FAQ names garage doors). For a single section, we check with the city's building department first, before anything is ordered.
Garage door panel questions
Often, yes, when the maker still produces that model and the damage is limited to one or two sections. We need the brand and model from the door's label to order an exact match, and on an older door the new section may look a shade brighter than the sun-faded ones.
Swapping a section usually wins when everything else on the door is solid and the model is still being made. With several damaged sections, a discontinued model, or no wind-rating label at all, a new door is often the better use of the money, and we write up both so you can compare.
That depends on the maker, and we pass on its date the day the factory confirms the order. Once the section is here, fitting it is a job of one to two hours.
Start with a photo
Point your phone at the door, or at the model label on the opener, and send the picture to (239) 880-9274. Calls and texts are answered at any hour, and you'll learn what it looks like, how long the fix should take and our first open slot.
One number for calls and texts. Your call gets answered, day or night.